Benassi BL304 Operating And Safety Instructions Manual page 36

he machine is packed in a box of the following dimensions :
WIDTH: 80 cm
◊
• Take the machine out of the carton box.
• Fit the two tillers to the main shaft using the delivered screws and nuts.
• Fit the rear spur in its place using the delivered bolt and both pins which are on the spur holder.
• Fit the handlebar on the support:
- The model with the vertical adjustment is fitted with two screws and nuts already fitted on the handlebar.
- The model with the full-side adjustment (rack, wheel system) is fitted with the parts already mounted on the handlebar
holder.
• The front wheel holder is fitted to the frame by means of two pins with cotter and spring. The small wheel has to be
fitted on the holder through screw and nut. To put the small wheel in the requested position pull outwards till the pin is
completely inside the buttonhole (see picture n.7).
• Fit the two guard-extensions to the main tiller protections fitted on the body of the machine using the proper screws and
nuts. The protection guards should reach a width of 60 cm according to CE norms.
• To make the transport easier it is possible to keep the handlebar disassembled, by means of the two screws in one
version or by means of the thread bushing in the other one, that fix it to the handlebar holder.
WARNING:
Please read very carefully this booklet before using your cultivator; Carefully using and servicing this machine,
you will certainly get satisfactory performances for a long time.. FAILURE TO COMPLY WITH THESE
INSTRUCTIONS MAY RESULT INSIDIOUS OR EVEN FATAL INJURY.
• The use of the machine is forbidden to persons younger than 16 years.
• The operator is responsible of any possible damage and he should always drive the machine carefully and safety.
• Before carrying the machine always empty the fuel tank.
• Before leaving the machine be sure that it is fully stopped.
• Never use the machine without heavy shoes and long transfers. Always inspect the area where you want to work taking
off stones, branches, cables and any other thing which can be dangerous.
• Before start working, make sure that a radius of minimum 5 mt. is completely free.
• Clean any possible leakage of fuel.
• Fill up when the engine is off and not hot, always in an open space far from fires or any heating source and refrain from
smoking during this operation.
• Before starting the machine make sure that you can quickly stop the engine and that you are familiar with the control
levers.
• Never allow the engine to run in enclosed spaces where the highly toxic carbon monoxide could not evacuate.
• Never start or use the machine not completely assembled especially concerning the safety devices and the tiller
protection guards which should always be completely assembled with all its extensions.
• Never fix or clean the tiller blades or any other tools when the engine is running.
• Attention ! Don't' use the machine on sloping grounds exceeding the 30%
• We are not responsible for accidents due to the wrong use of the machine neglecting the above basic instructions.
36
INSTRUCTIONS FOR MOTORHOE ASSEMBLY
HEIGHT: 70 cm
◊
SECURITY TERMS
BL300 BL350 BL304 BL354
LENGHT: 45 cm
◊