Toyota Prius 2011 Manual page 403

Hide thumbs Also See for Prius 2011:

Table of Contents

Programming a Rolling Code system (for U.S.A. owners)

If your device is Rolling Code equipped, follow the steps under the

heading "Programming the HomeLink

steps listed below.

Locate the training button

door opener motor. The exact location and color of the button

may vary by brand of garage door opener.

Refer to the operation manual supplied with the garage door opener

for the location of the training button

Press the training button

Following this step, you have 30 seconds in which to initiate step 3

Press and hold the vehicle's programmed HomeLink

for 2 seconds and release it. Repeat this step once again. The

garage door may open.

If the garage door opens, the programming process is complete. If

the door does not open, press and release the button a third time.

This third press and release will complete the programming process

by opening the garage door.

The ceiling mounted garage door opener motor should now recog-

nize the HomeLink

Repeat the steps above to program another rolling code sys-

tem for any of the remaining HomeLink

: Names such as "learn", "smart" or others vary according to manufac-

" before proceeding with the

on the ceiling mounted garage

transceiver and operate the garage door.

3-6. Other interior features