Table of Contents
Advertisement
FREESTANDING INSTALLATION (Cont.)
Hearth Stove Installation Using a Horizontal Connection
When installing a freestanding stove into a masonry fireplace that is using a horizontal connection, certain
precautions should be taken to insure a safe installation. A block-off plate is not needed for this type of
installation because the seal can be maintained simply by closing the damper and sealing with a non-
combustible material. The directions below illustrate one way to install your freestanding stove using a
horizontal connection to a masonry chimney. There are several other alternative methods. Check with
your dealer or installer for information on other options available to you.
1. Install the horizontal pipe section along with the necessary thimble assembly through the masonry
chimney according to the manufacturer's instructions for installation and support. Make sure to follow
all of the manufacturer's safety precautions during assembly. Inspect the masonry chimney and make
sure the chimney is in good and safe condition. If the existing chimney is not in good condition,
repairs should be made before installation. Make sure the masonry fireplace and positive connection
conform to all of the rules outlined in the section titled "CHIMNEY INFORMATION & REGULATIONS".
2. Close the damper and seal the edges with non-combustible material. It is a good idea to also remove
the damper control rod to avoid anyone trying to re-open the damper.
3. Follow all of the clearance regulations for placement of your stove specified in the sections titled
"FREESTANDING INSTALLATION - SPECIFICATIONS" and "PREPARATION FOR INSTALLATION -
FREESTANDING " . Furthermore, make sure the stove also meets the specifications listed in the
sections titled "FIREPLACE INSERT - SPECIFICATIONS" and "PREPARATION FOR INSTALLATION -
MASONRY FIREPLACE INSERT" for clearance to the masonry fireplace.
4. Place your stove into its final position so that the chimney connector will line up with the horizontal
pipe section.
5. Attach the chimney connector to both the horizontal pipe section and the hearth stove. It is a good
idea to check your connection by trying to rock the chimney connector back and forth. If it feels snug,
a good connection is established. If you can feel some play when you rock it back and forth, make
sure that the insert is properly aligned and that the connector fits tight into the flue collar on the top of
the insert.
7. Check the diagram on the following page. Make sure all of the items listed are complete.
Follow these directions in reverse order for periodic inspection and cleaning.
WARNING: Do not connect this unit to a chimney flue serving another appliance.
Do not use makeshift compromises in the installation.
Page 23
Advertisement
Table of Contents
