Horizontal Rotating Disks (Hrd) Components Removal - Travis Industries Deerfield Service & Troubleshooting Manual

Horizontal Rotating Disks (HRD) Components Removal

Make sure the stove has fully cooled (approximately 25 minutes) before conducting service. Unplug the
stove to prevent electrical shock.
It is very important that all of the internal components of the HRD assembly be reinstalled in the same
order as they were removed and in the same orientation.. We recommend that you create a space
where you can lay the parts out in order as you dismantle the HRD and clean the assembly to help
ensure that the installation order is maintained.
When the HRD is reinstalled, make sure that when you look down through the HRD assembly you can
not see all the way through the assembly, into the auger flight. If you can, you have changed the
orientation of some of the internal components. Contact Travis Industries Technical Support for
assistance. .
1. Remove all pellets from the hopper.
2. Using a ¼" nut driver remove the (6) ¼" screws that secure the HRD access panel to the hopper (set aside
for reinstallation).
3. Remove the HRD access panel. This will expose the top of the HRD assembly.
NOTE: You may want to use gloves when removing the plate to protect yourself from sharp edges.
17602010 - 12/15/17
Page 28