Message Alert Tone - VTech DS6151 A User Manual

Answering system settings

Message alert tone

When the answering system is turned on, the telephone base beeps every
10 seconds to alert you of new messages. The tone stops when all new
messages have been reviewed.
To change the setting:
Using the telephone base:
1. Press the MENU softkey when the telephone base is not in use.
2. Press the SELECT softkey to select Answering sys.
3. Press / or /
CID DIR
then press the SELECT softkey. The corresponding
icon, or
flashes on the screen.
1 2,
4. Press / or /
CID DIR
press the SELECT softkey.
5. Press / or /
CID DIR
press the SELECT softkey.
6. Press / or /
CID DIR
the SET softkey to confirm your setting or press
CANCEL to exit to the previous menu without making
any changes.
Using the handset:
1. Press the MENU softkey when the handset is not in use.
2. Press the SELECT softkey to select ANSWERING SYS.
3. Press or to select Mailbox 1 or Mailbox 2, then
press the SELECT softkey. The corresponding icon,
1
or , flashes on the screen.
2
4. Press or to select Ans sys setup, then press the
SELECT softkey.
5. Press or to select Msg alert tone, then press the
SELECT softkey.
6. Press or to select On or Off, then press the
SET softkey to confirm your setting or press the
BACK softkey to exit to the previous menu without
making any changes.
The answering system must be turned on for the message alert tone
to function.
to select Mailbox 1 or Mailbox 2,
to select Ans sys setup, then
to select Msg alert tone, then
to select On or Off, then press
29
1
# of rings
Remote code
Msg alert tone
SELECT
1
MSG ALERT TONE
On
Off
SET
1
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK SELECT
1
MSG ALERT TONE
On
Off
BACK SET