Table of Contents
Advertisement
Connect the jumper cables according to the following procedure:
3
Connect a positive jumper cable clamp to the positive (+) battery
terminal on your vehicle.
Connect the clamp on the other end of the positive cable to the
positive (+) battery terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery termi-
nal on the second vehicle.
Connect the clamp at the other end of the negative cable to a
solid, stationary, unpainted metallic point away from the battery
and any moving parts, as shown in the illustration.
Start the engine of the second vehicle. Increase the engine speed
4
slightly and maintain at that level for approximately 5 minutes to
recharge the battery of your vehicle.
Maintain the engine speed of the second vehicle and start the
5
engine of your vehicle by turning the engine switch to the "ON"
position.
Once the vehicle's engine has started, remove the jumper cables in
6
the exact reverse order from which they were connected.
Once the engine starts, have the vehicle inspected at your Toyota
dealer as soon as possible.
SEQUOIA_OM_USA_OM0C013U_19MY
7-2. Steps to take in an emergency
481
7
Advertisement
Table of Contents
