Connecting Accessories; Connecting A Control Input - Garmin CAMPERCAM 795 Owner's Manual

Hide thumbs Also See for CAMPERCAM 795:
Table of Contents

Advertisement

Connecting Accessories

Do not use the device to control or power a winch. Failure to follow this notice could cause damage to your
vehicle or your device.
Do not connect a power source to an accessory output terminal. Failure to follow this notice could cause
damage to your vehicle or your device.
Accessory requirements:
• Verify the amperage rating of each accessory before wiring it to the Garmin PowerSwitch device. The device
supports accessories up to 30 A for each channel and a maximum of 100 A for the entire system.
2
• Use 10 AWG (6 mm
) wires for accessories that use 20 to 30 A.
2
• Use 12 AWG (4 mm
) wires for accessories that use 10 to 20 A.
2
• Use 14 AWG (2.5 mm
• Use the appropriate size terminals for all accessory connections.
• Crimp all terminal connectors securely.
1 Connect the positive wire from the accessory
PowerSwitch device.
2 Connect the negative or ground wire
distribution block or directly to the negative terminal on the battery.
Do not connect the accessory ground wires to the ground terminal (GND) on the Garmin PowerSwitch device, as
doing so could result in personal injury or property damage, or could negatively impact device functionality.
3 Verify that all electrical connections are tight and will not come loose during use.

Connecting a Control Input

You can connect to the control terminals to enable the Garmin PowerSwitch device to turn on customisable
outputs. For example, you can connect your vehicle ignition switch to a control input terminal to turn on
accessories automatically each time you start your vehicle. The control terminals detect a signal from 3.3 V to
18 V. You can configure output functions with the Garmin PowerSwitch app.
Connect the control wire from the control source in your vehicle to one of the two control terminals on the
Garmin PowerSwitch device.
64
) wires for accessories that use less than 10 A.
to an unpainted ground stud
NOTICE
to one of the accessory terminals
on the vehicle frame, to a ground
CAUTION
on the Garmin
Appendix

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rvcam 795Avtex tourerthree plus

Table of Contents