Disconnecting A Usb Device; Connecting To A Document Camera; Connecting To An Hdbaset Transmitter - Epson EB-810E User Manual

Projector Connections
Attention
• Use the USB cable supplied with or specified for use with the device.
• Do not connect a USB hub or a USB cable longer than 3 meters, or the
device may not operate correctly.
c
Connect the other end to your device, if necessary.

Disconnecting a USB Device

When you have finished projecting with a connected USB device, disconnect
the device from the projector.
a Turn off and unplug the device, if necessary.
b
Disconnect the USB device from the projector.

Connecting to a Document Camera

You can connect a document camera to your projector to project images
viewed by the camera.
The connection method varies depending on your Epson document camera
model. See the document camera manual for details.
g g Related Links
• "Getting the Latest Version of the Documents"

Connecting to an HDBaseT Transmitter

To send an HDMI or RS-232C signal over a long distance, you can connect
the projector to an HDBaseT transmitter using a 100Base-TX network cable.
This is useful when you want to send a signal to or control the projector from
a remote location, such as in a hall or event site, since you can use a network
cable up to 100 m in length. To ensure proper data transmission, use a
p.9
Category 5e STP cable or better. However, operation is not guaranteed for all
input/output devices and environments.
• To enable communication from the Ethernet and serial ports on the
transmitter, set the Control Communications setting to On in the
projector's Signal I/O menu. Turning on this setting disables the
a
projector's LAN and RS-232C ports.
s Signal I/O > HDBaseT > Control Communications
• If you connected an Extron XTP transmitter or switcher to the
projector's HDBaseT port, set the Extron XTP setting to On in the
projector's Signal I/O menu.
s Signal I/O > HDBaseT > Extron XTP
• If you want to control the projector when the projector does not
project any images, set the A/V Output setting to Always On in the
projector's Signal I/O menu.
a Turn off the projector and HDBaseT transmitter.
Make sure the projector and HDBaseT transmitter are turned off
when connecting or disconnecting a network cable between the
two devices.
a
b Connect one end of the network cable to the HDBaseT port on the
transmitter.
c Connect the other end to the projector's HDBaseT port.
34