Solutions When The Image Contains Noise Or Static; Solutions When The Image Is Fuzzy Or Blurry; Solutions When The Image Brightness Or Colors Are Incorrect - Epson EB-810E User Manual

Solving Image or Sound Problems
g g Related Links
• "Correcting the Image Shape with Quick Corner"
• "Correcting Image Shape with Arc Correction"
• "Correcting Image Shape with Point Correction"

Solutions When the Image Contains Noise or Static

If the projected image contains electronic interference (noise) or static, try the
following solutions:
• Check the cables connecting your computer or video source to the
projector. They should be:
• Separated from the power cord to prevent interference
• Securely connected at both ends
• Not connected to an extension cable
• Adjust the Noise Reduction and MPEG Noise Reduction settings in the
projector's Image menu.
Image > Image Enhancement > Noise Reduction
s
Image > Image Enhancement > MPEG Noise Reduction
s
• Select a computer video resolution and refresh rate that are compatible with
the projector.
• If you adjusted the image shape using the projector controls, try decreasing
the Sharpness setting in the projector's Image menu to improve image
quality.
• If you connected an extension power cable, try projecting without it to see if
it caused interference in the signal.
• Make sure you selected the correct EDID setting in the projector's Signal
I/O menu, if available for your image source.
• If you are using the USB Display function, turn off the Transfer layered
window setting in the Epson USB Display Settings program on your
computer.
g g Related Links
• "Image Quality Settings - Image Menu"
• "Supported Monitor Display Resolutions"
p.58
p.61
p.63
p.181
p.251
• "Input Signal Settings - Signal I/O Menu"

Solutions When the Image is Fuzzy or Blurry

If the projected image is fuzzy or blurry, try the following solutions:
• Display a test pattern and use it to adjust the image focus using the focus
lever.
• Position the projector close enough to the screen.
• Position the projector so the keystone adjustment angle is not so wide that it
distorts the image.
• Clean the projection window.
To avoid condensation on the lens after bringing the projector in
from a cold environment, let the projector warm up to room
temperature before using it.
a
• Adjust the Sharpness setting in the projector's Image menu to improve
image quality.
• If you are projecting from a computer, use a lower resolution or select a
resolution that matches the projector's native resolution.
g g Related Links
• "Image Quality Settings - Image Menu"
• "Input Signal Settings - Signal I/O Menu"
• "Supported Monitor Display Resolutions"
• "Focusing the Image Using the Focus Lever"
• "Cleaning the Projection Window"
Solutions When the Image Brightness or Colors are
Incorrect
If the projected image is too dark or light, or the colors are incorrect, try the
following solutions:
p.183
p.181
p.183
p.251
p.56
p.216
236