Epson EB-810E User Manual page 203

Projector Network Settings - Network Menu
Setting Options
PJLink Password Up to 32
alphanumeric
characters
(do not use spaces
and any symbols
other than @)
Notified IP Address Various IP
addresses
SNMP On
Off
Trap IP Address 1 Various IP
addresses
Trap IP Address 2
Community Name Up to 32
alphanumeric
characters
(do not use spaces
and any symbols
other than @)
AMX Device On
Discovery
Off
Description
Enter a password for using the PJLink
protocol for projector control.
You must set the PJLink Password when
using the PJLink function for the first
time.
Enter the IP address to receive the
projector's operating status when the
PJLink notification function is enabled.
Enter the addresses using 0 to 255 for
each address field.
Do not use these addresses: 127.x.x.x or
224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255).
Set to On to monitor the projector using
SNMP. To monitor the projector, you
need to install the SNMP manager
program on your computer. SNMP
should be managed by a network
administrator.
Enter up to two IP addresses to receive
SNMP notifications, using 0 to 255 for
each address field.
Do not use these addresses: 224.0.0.0
through 255.255.255.255 (where x is a
number from 0 to 255).
Enter the SNMP community name.
You must set the Community Name
when using the SNMP function for the
first time.
Set to On when you want to allow the
projector to be detected by AMX Device
Discovery.
Setting Options
Crestron On
Connected
Off
Crestron XiO On
Cloud
Off
Control4 SDDP On
Off
Art-Net On
Off
Secure HTTP On
Off
Web Server —
Certificate
203
Description
Set to On only when monitoring or
controlling the projector over the
network using Crestron Connected.
Enabling Crestron Connected disables
the Epson Message Broadcasting feature
in the Epson Projector Management
software.
Set to On to monitor or control your
projector and other devices over the
network using the Crestron XiO Cloud
service.
Set to On to allow device information to
be acquired using Control4 Simple
Device Discovery Protocol (SDDP).
Set to On when you want to control the
projector using Art-Net.
• Net: enter a number for the projector's
Net using 0 to 127 (default is 0).
• Sub-Net: enter a number for the
projector's Sub-Net using 0 to 15
(default is 0).
• Universe: enter a number for the
projector's Universe using 0 to 15
(default is 0).
• Start Channel: enter the start channel
that handles Art-Net using 1 to 495
(default is 1).
To strengthen security, communication
between the projector and computer in
Web control is encrypted. When setting
security with Web control, it is
recommended to set this to On.
Imports the Web server certificate for
secure HTTP.