Cisco C1109-2PX Upgrade page 6

Install a Pluggable Interface Module
Install a Pluggable Interface Module
Warning
Warning
Warning
Install a Pluggable Interface Module on a C1101-4P
To insert the pluggable interface module into the router, follow these steps:
Step 1 Insert and then gently push the LTE pluggable into the pluggable slot of C1101-4P until firmly fixed.
Step 2
Tighten the screw, the recommended torque is 10-12 in-lb.
Figure 1: LTE Pluggable Interface Module - C1101-4P
1
2
Install and Upgrade Internal Modules and Field Replaceable Units
6
Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages
and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other
equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all
cards, faceplates, front covers, and rear covers are in place. Statement 1029.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030.
Pluggable optical modules comply with IEC 60825-1 Ed. 3 and 21 CFR 1040.10 and 1040.11 with or without
exception for conformance with IEC 60825-1 Ed. 3 as described in Laser Notice No. 56, dated May 8, 2019.
Statement 1255.
Install and Upgrade Internal Modules and Field Replaceable Units
GPS antenna (SMA)
LTE antenna (SMA)