Cisco C1109-2PX Upgrade page 11

Install and Upgrade Internal Modules and Field Replaceable Units
Note Ensure to use the correct tool for removing the Micro-SIM door.
1. Place the pluggable module on its bottom side, remove the SIM door screw, use a #1 Philips screw driver
for removing the screws, and then carefully remove the Micro-SIM cover from the pluggable module.
Caution
2. Slot 1 and slot 0 are the Micro-SIM slots. (see figure 5, step 2).
3. Install SIM 0 and SIM 1 in their respective slots. SIM 0 or SIM 1 is marked on the pluggable interface
module above the Micro-SIM cover. The SIM icons show the correct orientation required to install the
SIM into each respective connector (SIM connectors are a push-push type).
To install, insert the SIM card in the connector until you feel it click, then let go and the SIM is locked
to the connector. To remove the SIM card, depress the SIM in the connector slot again until you feel the
same click and let it go, the SIM connector should eject part way out of the connector. The SIM card can
then be grabbed and removed).
Secure the Micro-SIM cover with a screw, use a number 1 Philips screw driver to secure the screw on the
Micro-SIM cover. The recommended torque is 2.8 - 3.8 inch LBF.
Note
4. You have now successfully inserted the Micro-SIM cards into the LTE pluggable module. The marking
on the Mirco-SIM door should align with Micro-SIM 0 on the pluggable module with the arrow pointing
upward.
Do not touch any part of the exposed PCB circuit area when the Micro-SIM cover is removed.
We recommend using industrial-grade SIM cards.
Install a Pluggable Interface Module on a C1101-4P
Install and Upgrade Internal Modules and Field Replaceable Units
11