Getting Started - Vax SteamFresh REACH Manual

BEFORE YOU BEGIN
CAUTION: The steamer and accessories get very hot during use, always allow them to cool down before handling, or
changing to handheld or steam wand mode. Always switch off and unplug the steamer when assembling. Always switch
off the steamer before emptying the twin tank or changing the cloths/accessories.
CAUTION: This steamer is not free standing, always stand using the wall bracket or securely against a wall/fixed
structure, alternatively lie the steamer flat on the floor in a suitable location so it does not become a trip hazard or can be
stepped on.
IMPORTANT: Please refer to floor/surface manufacturer's care recommendations before use and test the steamer on a
hidden area to begin with. Test for colour fastness in a small hidden area of upholstery/fabric to check for colour removal
before use. When using the steamer, basic safety precautions should always be observed. Don't aim the steamer at
people, animals, plants, and electrical components or wires. Never touch the steam jet or floorhead from a short distance
(there is a risk of scalding). The steamer is equipped with a thermostat and a thermal cut-out. If for any reason the
steamer overheats it will switch off. If this happens switch off and unplug the steamer, allow to cool for a least 2 to 4
hours and re-try.
Assembling the steamer
Grip the steam reach
wand. Push the steam
reach wand down into
the floorhead until
it clicks into place.
Fixing the wall bracket
Grip the steam reach
wand. Push the handheld
down onto the steam
reach wand until it clicks
into place.
The wall bracket can be fixed against
the wall by either adhesive strips or screw

Getting started

The steamer is not free standing and must always be
stood either in the wall bracket or safely and securely
against a wall or fixed structure when not in use.