Advertisement
Available languages
Available languages
Using your machine
IMPORTANT: When using on carpets, always make sure the microfibre cleaning pad covers the floorhead entirely
before using the carpet glider. Only use the carpet glider when refreshing carpets.
Never leave the floor steamer in one spot for extended period of time or with a damp or wet pad attached
as this may damage the floor surface.
Refreshing carpets
Place the microfibre
pad on the floor white
side facing up.
Place steamer onto
pad making sure the
entire pad covers
the floorhead.
Pull handle backwards
to recline.
After refreshing carpets, switch off and unplug the
steamer. Allow the steamer to cool down. Hold the
corner of the microfibre pad down with your foot
and lift steamer to peel away.
With microfibre pad
attached, slide the
floorhead into the carpet
glider, then push the
back of the floorhead
downwards into the clip
to secure. The carpet
glider should only be used
when refreshing carpets.
To produce steam squeeze
the trigger in short bursts.
To prevent over wetting
carpets avoid holding the
trigger continuously.
Plug the steamer into
mains and slide the
On/Off switch to "On".
The green light will
illuminate when it is ready
to use. The steamer will
automatically set to Max
steam (no detergent).
Move the steamer slowly
backwards and forwards
across the carpet.
To refresh your carpets
press the button on the
control panel to select
Steam only LOW.
Do not use detergent
when refreshing carpets.
When releasing the carpet
glider, ensure the steam
trigger is fully released
first. To release the carpet
glider, place your foot on
the clip and press down.
Lift steamer out of the
glider to remove.
Advertisement
