Stay Arming The System With The Keypad; Silent Exit Delay; Night Arming The System With The Keypad - DSC neo HS2064 E User Manual

Chapter 3
6. Once the exit delay timer expires, thereby arming the system, the:
Ready indicator turns off.
l
Armed indicator remains on.
l
Keypad stops sounding.
l
Note: The installer configures the exit delay timer and whether or not an access code is required for arming the system.

3.2 Stay Arming the System with the Keypad

Stay mode partially activates your alarm system by:
Arming all perimeter sensors.
l
Bypassing all interior sensors.
l
To Arm the System in Stay mode
1. Ensure all windows and doors are closed and that the Ready indicator is on.
2. Press and hold the Stay key
or present your proximity tag. Do not leave the premises.
3. If zones have been bypassed, ICN or LED keypads bypass LED
bypassed zones #s will be shown. On an LCD keypad a warning appears
4. After successfully initiating the arming sequence the:
Armed indicator turns on.
l
Ready indicator remains lit.
l
Exit Delay timer begins counting down.
l
5. To cancel the arming sequence, enter your [access code] or present your proximity tag.
6. Once the exit delay timer expires, thereby arming the system, the:
Ready indicator turns off.
l
Armed indicator remains on.
l
Bypass or system indicator activates.
l

3.2.1 Silent Exit Delay

If the system is armed using the Stay key
The warning beep is silenced.
l
The exit time is doubled for that exit period only (CP-01 versions only).
l
Note: For non CP-01 versions, Standard Exit Time is used.

3.3 Night Arming the System with the Keypad

Night mode partially activates the alarm system by:
Bypassing all internal sensors configured as Night zones.
l
Arming all perimeter sensors.
l
Armingall other internal sensors.
l
Arming the system in Night mode is possible after the system has first been armed in Stay mode and [*][1] is pressed at the
keypad. The keypad can also be configured with a function key to arm the system in Night mode. To access armed interior areas
when the system is armed in Night Mode, you must disarm the system.
Note: Ensure that your installer has provided you with a list identifying all programmed night zones. Your installer can configure a
function key to arm the panel in Night mode without the system already being armed in Stay mode.
for 2 seconds and, if required, enter your [access code]
or the No Entry Arming method [*][9]:
- 9 -
System Armed
in Away Mode
Date Time
JAN 02/13 2:06a
System is
Ready to Arm
Enter Your
Access Code
* Warning *
will light and the
Bypass Active
Exit Delay in
Progress
System Disarmed
No Alarm Memory
System Armed
in Stay Mode
LCD Display
then