Entry Arming; Leaving When The System Is Already Armed - Quick Exit - DSC neo HS2064 E User Manual

Chapter 3
To Arm the System in Night mode
1. If configured, press and hold the Night Arm key for 2 seconds.
OR
2. Once the system is armed in Stay mode (Armed
press [*][*].
OR
press[*][1].
3. If required, enter your [access code]. All interior zones will now be armed, except
for devices programmed as Night Zones.
The Night mode icon turns on.
l
To gain access to interior areas that are armed during Night mode disarm the system by entering your [access code].
3.4 No-Entry Arming
No-Entry Arming arms the system in Stay mode by:
Removing the Entry Delay from all configured zones.
l
Arming all perimeter sensors.
l
Bypassing all interior sensors.
l
An entry through any zone will create an instant alarm.
To No-Entry Arm the System
1. Check that the Ready indicator
2. Press [*][9] and, if required, enter your [access code].
3. If zones have been bypassed, ICN or LED keypads bypass LED will light and the
bypassed zones #s will be shown. On an LCD keypad a warning appears.
4. After successfully initiating the arming sequence the:
Armed light flashes as a reminder that the system is armed and has no entry delay.
l
Keypad sounds fast beeps.
l
Keypad displays "Exit Delay in Progress".
l
5. To cancel the arming sequence, enter your [access code] or present your proximity
tag.
6. Once the exit delay timer expires, the system is armed.

3.5 Leaving when the System is Already Armed - Quick Exit

Use the Quick Exit feature if the system is already armed and you would like to leave without disarming and rearming the system.
Quick Exit uses the same hot keys as Quick Arming, and it provides you with a two minute exit delay to leave the premises without
triggering an alarm. Once the door you leave from closes, the quick exit timer will be canceled.
To Quick Exit
1. When the system is already armed and the Armed
Quick Exit key for 2 seconds
OR
press [*][0].
2. Exit the premises before the exit delay timer expires. After exiting, the delay timer will be
canceled.
indicator is on) at any keypad
is on and your system is ready to be armed.
light is lit, press and hold the
- 10 -
LCD Display
Date Time
JAN 02/13 2:06a
then
Press (*) for <>
Interior Arm
Present Tag or
Enter Code
then
Interior Has
Been Armed
LCD Display
Date Time
JAN 02/13 2:06a
Present Tag or
Enter Code
* Warning *
Bypass Active
then
Armed With No
Entry Delay
then
Exit Delay in
Progress
System Disarmed
No Alarm Memory
System Armed
in Stay Mode
LCD Display
Quick Exit in
Progress