Stay Arming; Arming Without Entry Delay; Quick Arm; Aut O Arm Ing - DSC Power832 User Manual

Alt e rna t e Arm ing M e t hods
Away Arming
Arming the system in the Away mode will have all interior zones and perimeter zones active. If motion
is detected in the interior zones, or if one of the perimeter zones is violated, the alarm sequence will
begin. To arm in the Away mode, enter your access code and exit the premises through a designated
Exit/Entry door. The system will recognize that occupants have left the premises. Once the exit delay
expires, the system will be fully armed.
Audible Exit Fault
In an attempt to reduce false alarms, the Audible Exit Fault is designed to notify you of an improper
exit when arming the system in the Away mode. In the event that you fail to exit the premises during
the allotted exit delay period, or if you do not securely close the Exit/Entry door, the system will notify
you that it was improperly armed in two ways: the keypad will emit one continuous beep and the bell or
siren will sound. If this occurs, you must re-enter the premises, enter your access code to disarm the
system, and then follow the arming procedure again, making sure to exit the premises in the proper
fashion.

Stay Arming

This feature, if enabled by your installer, will allow you to arm the perimeter zones while leaving the
interior zones inactive so that you can remain on the premises while the system is armed. When you
enter your security code to arm the system and do not exit the premises through a designated Exit/
Entry door, the system will arm in the Stay mode, automatically bypassing the interior zones.
The interior zones can be reactivated at any time by entering [
the interior zones, be sure to only inhabit areas not covered by motion detectors. To access areas
protected by motion sensors, you must enter your security code and disarm the system.

Arming Without Entry Delay

If you wish to arm your system without the entry delay, enter [
light will flash as a reminder that the system is armed and has no entry delay. An entry through any
zone programmed as a delay zone will create an instant alarm.

Quick Arm

When the Quick Arm feature is enabled, the system may be armed by simply pressing [
your access code. Please note that pressing [
you must enter a valid access code. Your installer will inform you if the Quick Arm feature has been
enabled on your system.

Aut o Arm ing

Your system can be programmed to automatically arm itself according to a programmed schedule.
Auto arming is programmed by partition. Thus, all auto arm programming must be performed from a
keypad assigned to the partition you wish to program.
To program the auto arm time, enter [
using the military format (HH MM).
To enable or disable the auto arm feature, enter [
either enable or disable the feature. The keypad will beep 3 times if the feature is ON and once if it is
OFF.
NOTE: The correct system time and date must be programmed in order for the auto arm feature
to function properly. Please see "Setting the System Date and Time" on page 13 for instructions.
✱ ][0] will only allow you to arm the system; to disarm,
✱ ][6] followed by your master code. Press [3]. Enter the time
][6] followed by your master code. Press [2] to
✱
✱ ][1] at any keypad. If you reactivate
✱ ][9] then your access code. The Armed
✱ ][0] instead of
5