Remove The Solid-State Drive (Ssd) Module - Lenovo IdeaPad 5i Hardware Maintenance Manual

Screw specifications
M2 x L3
Go to https://support.lenovo.com/partslookup
part:
Battery pack

Remove the solid-state drive (SSD) module

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 34
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw and then remove the SSD by pulling it away from the slot.
Figure 8. Remove the SSD
Screw specifications
M2 x L3
Step 3. Peel off the SSD mylar.
Figure 9. Peel off the SSD mylar
Step 4. Remove one screw and then remove the SSD and SSD bracket.
36
Hardware Maintenance Manual
Number of screws
2
to look up the Lenovo part number of the following replacement
Number of screws
1