Omron BP6100 Instruction Manual page 27

Display/Problem
appears
flashes
appears or the
monitor is turned off
unexpectedly during
a measurement
No power.
Nothing appears on
the display of the
monitor.
Readings appear too
high or too low.
Any other problems
occur.
Possible Cause
The monitor is
malfunctioned.
Batteries are low.
Batteries are depleted.
Batteries are completely
depleted.
Battery polarities are not
properly aligned.
Blood pressure varies constantly. Many factors including
stress, time of day, and/or how you apply the wrist cuff, may
affect your blood pressure. Review sections 2.3 - 2.5 and
chapter 3.
Press the [START/STOP] button to turn the monitor off, then
press it again to take a measurement. If the problem
continues, remove all batteries and wait for 30 seconds.
Then re-install batteries.
If the problem still persists, contact customer service. Refer
to chapter 10.
Press the [START/STOP]
button again. If "Er" still
appears, contact customer
service. Refer to chapter 10.
Replacing all batteries with 2
new alkaline batteries is
recommended. Refer to
section 2.1.
Immediately replace all
batteries with 2 new alkaline
batteries. Refer to
section 2.1.
Check the battery installation
for proper placement. Refer
to section 2.1.
27
Solution