Design Selection; Screen Configuration - Orion MLCD OLMU-4620S User Manual

5.4. Design Selection

• You can see following pop-up window for "New design/Last design" when you click "Connect" or press "Ctrl+C" using
keyboard after select communication type.
New/Last Design Set
• Click "Open New Design" to prepare new configuration.
• Click "Open Last Design" to go to last design before closing.
• When the connection is successfully completed after setting Com Port, following Message dialog is displayed. The
dialog window will be disappeared in 1 second.
• When the connection is successfully completed after setting Lan Port, following Message dialog is displayed. The dialog
window will be disappeared in 1 second.
• After Connection, Turn on all of the connected MLCD sets by clicking "Power On" button in Broadcast.
- 40 -

5.5. Screen Configuration

1. Input the numbers of X and Y
- X is for the number of row and Y is for column.
- X and Y can be selected within the range from 1 to 15. The maximum MLCD quantity of MSCS control is 100 sets.
- MLCD image of selected numbers of X and Y is displayed in the Screen configuration in one second after setting the number.
Screen Configuration Setting
2. Select one of input sources from DVI, PC , HDMI1, HDMI2 or DP Port
3. Execution of the configuration.
- When you click "PLAY"button after selecting input source from Source select and the numbers of X and Y in MLCD Configuration,
the configuration of MLCD is generated as shown in the figure below.
DVI DVI
DVI DVI
DVI DVI
※ INFO※:※ ※
- Check the resolution of the input source. It is displayed at the upper right corner of the screen.
- Check the signal. If there is no input signal, "No signal" is displayed.
DVI
DVI
DVI
- 41 -