Assembling The Light Kit - Hunter Tailwind Installation Manual

Remove a pre-installed assembly
screw. It does not matter which
screw you choose.
Insert the saved assembly screw. Firmly tighten all
the three screws.
WARNING
Note:
FAN FALL HAZARD
Fan style may vary.
Make sure all screws are tight to secure
the light fixture.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Note:
Fan style may vary.
Ceiling Bracket Hanging Fan

Assembling the LIght Kit

1 of 1
Assembly Screw
Feed the 9-pin plug connector coming
from the bottom of the motor housing
through the center hole in the light kit
assembly. Connect it to the plug connector
found in the switch housing area of the
light kit assembly. Make sure to line up
the colored markings on the connectors.
1 of 1
Assembly Screw
Carefully push all switch housing components
into the switch housing, then install the switch
housing plate using two short light kit assembly
screws, found in the
Installing the Bulbs and Glass
Notch
Lift the globe and align the notches in
the globe with the tabs in the light kit.
Wiring Canopy
hardware bag.
Tab
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades Light
Align the keyhole slots in the top of the light kit
assembly with the partially installed screws.
Wrap the keyhole slots around the screws and
twist counterclockwise.
2 of 2
Short Light Kit
Screw
bag
ON
WARNING
Glass/Bulbs Remote
1886
8