Related Manuals for Hunter Tailwind 51289
Summary of Contents for Hunter Tailwind 51289
- Page 1 Tailwind Installation Manual Model: 51289 Matte Silver 51290 Noble Bronze 51918 Matte Black 51919 Matte Silver Fan weight ±2 lbs: 19.6 lbs (8.9 kg) ©2022 Hunter Fan Co. PG3975 r022222...
- Page 2 - All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. c.2 - Use only Hunter replacement parts. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 3 We recommend that you pull everything out of the box and lay it out. We have grouped the drawn components below with the hardware you’ll need for those Hunter Pro Tip: parts. The screws below are drawn to scale to make it easier to identify what piece of hardware is needed to install each component.
-
Page 4: Choosing The Right Installation Location
A little more information on Angled Mounting: For optimum performance and appearance, a longer downrod should be used with your Hunter ceiling fan when installing on high or angled ceiling. If your ceiling is angled greater than 34° you will also need an Angled Mounting Kit. -
Page 5: Installing The Ceiling Bracket
You have two options for installation. Pick which one works best for your location. Remove any existing Hunter Pro Tip: bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box. The machine screws are the ones that came with your outlet box. -
Page 6: Hanging The Fan
1886 Hanging the Fan NOTICE To prevent damage to fan, ALWAYS lift holding either the fan housing or the downrod. Place the downrod ball into the slot in the ceiling bracket. Ceiling Bracket Hanging Fan Wiring Canopy Blades Light Glass/Bulbs Remote... -
Page 7: Wiring The Fan
Follow these steps to get your fan wired quickly and safely. Follow the route below that best matches your wall switch setup. If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a qualified electrician. Hunter Pro Tip: Here is how to connect the wires: Push the bare metal ends of the wires together and slide a wire nut over them. -
Page 8: Installing The Canopy
1886 Installing the Canopy Insert the two canopy screws found in the hardware bag. Canopy Screw Lift the canopy into place so that the screw holes are aligned. Installing the Blades Put the blade washers, found in the hardware bag, onto the blade screws, found in the hardware bag. -
Page 9: Assembling The Light Kit
1886 Assembling the LIght Kit 1 of 1 Assembly Screw Feed the 9-pin plug connector coming Align the keyhole slots in the top of the light kit from the bottom of the motor housing assembly with the partially installed screws. through the center hole in the light kit Remove a pre-installed assembly Wrap the keyhole slots around the screws and... - Page 10 1886 Installing the Pull Chains The fan pull chain The light pull chain controls the speed: controls the light from high to off. fixture: on and off. Remove and discard the plastic connectors from the ends of the short pull chain. Feed the pull chains from the fan switch and the light switch down through the holes in the upper switch housing as shown.
-
Page 11: Preparing The Remote Control
• Turn the power off, support the fan carefully, and check that the hanger ball is properly seated. • Use the provided balancing kit and instructions to balance the fan. Hunter Pro Tip: Noisy Operation Cleaning the Fan • Make sure the blades are properly installed. -
Page 12: Limited Lifetime Warranty
Hunter instructions, accidental damage caused by the fan owner or related parties, Please do not ship your fan or any fan parts to Hunter. Delivery will be refused. modifications to the fan, improper or incorrectly performed maintenance or repair,...