Table of Contents
Advertisement
Replacement procedure
Note: During the installation, ensure that you align the memory module to the slot and press down on both
ends until the latches are fully engaged with a click.
E-lock
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove the "Left side cover" on page 54.
2. Disconnect the E-lock cable from the system board.
Note: To remove the screws, you need a special tool (T15 star wrench).
Removal steps
Step
Screw (quantity)
1
M3 × 5 mm, Nickel coated (1)
Torque
5.0 ± 0.5 in-lb
.
Chapter 7
Hardware removal and installation
85
Advertisement
Table of Contents
