Brother FAX218 Service Manual page 47

(7) To separate the FPC key from the control panel PCB, unlock the FPC key connector
and disconnect the FPC key.
(8) For the FAX335MC/FAX228MC: Take out the microphone* and its harness* from
from the control panel.
Main-mic harness*
(9) To take out the LCD, remove the control panel PCB and the FPC key in step (6). Pull
up the clamps with your fingers and take out the LCD to the front, as shown below.
Clamp
Reassembling Notes
• When installing the LCD, take care not to scratch or damage the cover sheet. Replace it
if scratched or damaged.
• A new LCD is covered with a protection sheet. Before installing it, remove the protection
sheet.
* Provided on the FAX335MC/FAX228MC.
LCD
(Rear)
IV – 12
Bosses
Control panel
Guides
Clamp