Using The Px-760A Self-Test Diagnostics - Plextor PX-760 Installation And User Manual

Section 5. Maintenance and Troubleshooting

Using the PX-760A Self-Test Diagnostics

The PX-760A drive contains a set of self-test diagnostics that can help
isolate trouble and determine if a problem is in the drive or elsewhere.
NOTE: Using the self-test diagnostics requires opening the computer and
removing a cable from the drive, then replacing the cable at the end of
the test. If you previously installed the PX-760A in your computer, you
should have no fear of the simple procedures that are required. However,
if you're are not comfortable with opening your PC and disconnecting
cables, you may want to let someone with more experience handle this
aspect of troubleshooting for you.
To perform the tests you'll need:
• Tools to remove the computer's cover
• An extra jumper (supplied)
• A blank piece of Plextor-recommended DVD+R, DVD-R, or CD-R
media. (See page 78 or visit our web site.) The self-test will write to
this media, so you won't be able to use this disc again.
This tests three functions of the drive: writing at maximum speed,
continuous playback at maximum speed, and random access.
To perform the self-test:
1. Turn the computer's power OFF, unplug it from its power source,
and open the computer to gain access to the rear of the PX-760A
drive. Typically, this involves loosening or removing several screws
on the back panel of your computer and sliding off the cover. (See
Figure 3 for an example.)
CAUTION: Before you attempt to open your computer be sure to
properly ground yourself by wearing an anti-static wristband. This will
help prevent static damage to your computer system.
2. You should be able to see the back of the PX-760A drive connected
to the ATAPI cable, power connector, and, optionally, a digital
sound cable.
64
PX-760 Installation and Users Manual