Plextor PX-760 Installation And User Manual page 53

Section 3. Installing the PX-760SA Internal SATA Drive
6. Plug one connector of the 7-pin SATA interface cable into the SATA
connector (the right-hand connector) on the rear panel of the drive
before you insert the drive into your computer. Then thread the cable
through the front of the open bay and back toward the motherboard.
The drive should slide smoothly into the bay. If it does not, check for
obstructions in the bay and ensure the side rails are attached
properly.
Figure 24: Cable connections for an internal SATA drive
NOTE: Your computer's SATA connection must support the ATAPI
command set. Some computer motherboards have SATA RAID
(Redundant Array of Independent Discs) chipsets that do not support
the command set used by optical disc drives, or that do not have
BIOS settings to enable IDE/ATAPI functions. If you are unsure,
consult your motherboard manual or vendor web site for compatibility,
BIOS versions, and BIOS settings. And check the Plextor PX-760SA
motherboard compatibility listing at
http://www.plextor.com/english/support/support_compatability.html
45
PX-760 Installation and Users Manual