Plextor PX-760 Installation And User Manual page 43

Figure 17: Cable connections for an internal IDE drive
10. Connect a digital audio cable if your sound board is equipped with
the Sony/Philips Digital Interface (SPDIF) or Digital-In, and you
wish to use the digital audio output from your PX-760A. This cable
runs from the digital audio output connector pins on the PX-760A
back panel to the sound board. (This cable is not supplied by
Plextor.)
11. Mount the PX-760A drive in the computer using the four screws that
were supplied with your drive. Use only these screws.
CAUTION: Do not mount your drive in your computer using screws
other than those supplied by Plextor. You may damage the drive if
you insert screws that are too long or the wrong thread type.
This completes the installation procedure. Go to "Section 4. Using Your
PX-760" on page 47 to see how to use your PX-760A drive.
Section 2. Installing the PX-760A Internal ATAPI Drive
PX-760 Installation and Users Manual
35