Connect The Px-708Uf Drive; Record The Serial Number And Tla Code; Install The Drive In Your Windows Computer - Plextor PX-708UF Installation And User Manual

Connect the PX-708UF Drive

Before proceeding to install the Plextor PX-708UF drive on your
personal computer, record the serial number.

Record the Serial Number and TLA Code

Record the serial number and TLA number of your drive on the inside
front cover of this manual.

Install the Drive in Your Windows Computer

If you have a computer with Windows XP, Windows 2000 or Windows
Me, use the following procedure to install your PX-708UF drive.
(Windows 98SE users, see page 19, then come back here after you have
updated your Windows installation.)
To install the PX-708UF drive in a Windows-based computer:
1. Turn ON your computer system.
2. Set the interface switch at the rear of the PX-708UF drive to USB
(switch to the right) if you are using a USB cable; or to 1394 (switch
to the left) if you are using IEEE 1394 (FireWire).
3. Connect the AC adapter to your PX-708UF as shown in Figure 3.
4. Turn the drive's power switch ON (the "1" side is down).
5. Connect the USB or IEEE 1394 (FireWire) cable from your PX-
708UF drive to the computer.
Section 2. Installing Your PX-708UF External Drive
PX-708UF Installation and Users Manual
17