Plextor PX-708UF Installation And User Manual page 17

• Interface switch: Switch the PX-708UF drive to operate with a
different interface (USB, IEEE 1394). This allows you to connect the
drive to either interface, depending on the requirements of your
computer. If you change interfaces with this switch, you must also
cycle the PX-708UF power. (That is, turn the power switch off, then
on again.)
• USB 2.0 connector: Connect the USB cable here. You can use a
USB 2.0 or USB 1.1 interface.
CAUTION: Use only the USB cable shipped with your PX-708UF.
• DC 12 V power connector: Connect the AC adapter here.
CAUTION: Use only the AC adapter shipped with your PX-708UF.
• Power switch: Press this switch to turn the power on or off. Press
the "0" down to turn power off. Press the "1" down to turn power on.
• SELF TEST switch: Set switch to the right (off) for normal
operation, or set it to the left (ON) to execute the self-test diagnostic
routine. To execute a self-test: 1) Disconnect the USB or FireWire
cable, 2) turn the drive power switch OFF, 3) set the SELF-TEST
switch ON (left), 4) press and hold the eject button while turning the
power switch ON, and 5) insert a blank CD or DVD disc.
Section 1. Getting Started
PX-708UF Installation and Users Manual
11