Connect The Px-750Uf Drive; Record The Serial Number And Tla Code; Install The Drive In Your Windows Computer - Plextor PX-750A Installation And User Manual

Section 3. Installing the PX-750UF External USB/FireWire Drive

Connect the PX-750UF Drive

This section explains how to install your drive (that is, how to connect it
to your computer).

Record the Serial Number and TLA Code

Before proceeding to connect the Plextor PX-750UF drive to your
personal computer, record the serial number and TLA number of your
drive on the inside front cover of this manual.

Install the Drive in Your Windows Computer

If you have a computer with Windows XP or Windows 2000, use the
following procedure to install your PX-750UF drive.
To install the PX-750UF drive in a Windows-based computer:
1. Turn ON your computer system.
2. Set the interface switch at the rear of the PX-750UF drive to USB
(switch to the right) if you are using a USB cable; or to 1394 (switch
to the left) if you are using IEEE 1394 (FireWire).
3. Connect the AC adapter to your PX-750UF as shown in Figure 19.
4. Turn the drive's power switch ON (the "1" side is down). The power
indicator is illuminated when power is on.
5. Connect the USB or IEEE 1394 (FireWire) cable from your
PX-750UF drive to the computer.
42
PX-750 Installation and Users Manual