Handset Battery - Clarity Professional C4205 User Manual

8. Set the Tone/Pulse switch located on the
end of the base to correct dialing mode.
Please check with your local Phone Com-
pany if uncertain of the type of service.
9. Place handset in the cradle to begin initial
charging. Remember, you must charge the
phone for at least 12 hours before you use
the phone for the first time.
Note: Remember, you must charge the phone for
at least 12 hours before you use the phone for
the first time.
HANDSET BATTERY INSTALLATION
The C4205 uses a 3.6Volt 600mAh NiMH
rechargeable 3 cell (AAA Type) battery that is
included with your unit.
Handset Battery must be connected before
beginning initial charging
To Install a New Battery
1. Remove battery cover
2. Install new battery
3. Connect battery pack
4. Replace battery cover
5. Charge for 12 hours before first use
Handset Battery Charging
1. Place the handset in the base. The
CHARGE LED on the base will light RED.
2. After the batteries are fully charged,
check for dial tone by pressing TALK on
the handset.
Battery
Connector
Compartment
Installing and
connecting battery
Note: The battery in the
handset must be fully
charged for 12 hours
before using the tele-
phone for the first time.
Battery
Pack Plug
Battery
Cover
13