11
SERVICE WORK ON THE CHASSIS
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Avoid contact of the fuel with skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse imme-
diately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed,
contact a doctor immediately. Change clothing that has come into contact with fuel.
11.35
Checking for chain dirt accumulation
Main work
–
Check the throttle cable routing. (
–
Position the fuel tank and fit the two spoilers to the sides of the radiator bracket.
–
Make sure that no cables are trapped or damaged.
–
Mount the fuel tank breather.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
101357-11
–
Position the horn, and fit and tighten screws
Guideline
Remaining screws, chassis
101356-11
–
Connect the electrical plug-in connection
–
Thoroughly clean the plug-in connection of the fuel line using compressed air.
Info
Never let dirt enter the fuel line. Dirt in the fuel line clogs the injection
valve.
–
Remove the wash cap set. Lubricate the O-ring and connect plug-in connection
of the fuel line.
B01236-10
Info
Route the cable and fuel line at a safe distance from the exhaust system.
Finishing work
–
Mount the seat. (
–
Check the chain for coarse dirt accumulation.
»
If the chain is very dirty:
–
Clean the chain. (
400678-01
p. 66)
with the rubber bushing.
1
M6
2
M6
.
3
p. 56)
p. 62)
10 Nm (7.4 lbf ft)
with collar bushings.
10 Nm (7.4 lbf ft)
61
4