Adjusting The Play Of The Steering Head Bearing (Exc-F Six Days); Greasing The Steering Head Bearing; Removing The Front Fender - KTM 350 EXC-F EU 2013 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.16 Adjusting the play of the steering head bearing
11.17

Greasing the steering head bearing

11.18

Removing the front fender

Finishing work
–
Check the steering head bearing play.
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Fully tighten screws
Guideline
B01234-10
Screw, top triple clamp
–
Mount and tighten screw
Guideline
Screw, top steering stem
Finishing work
–
Check the steering head bearing play.
–
Remove the motorcycle from the lift stand. (
x
(EXC-F SIX DAYS)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
(EXC‑F EU, EXC‑F AUS, XCF‑W)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
–
Remove screws
–
Make sure the spacers remain in place.
101345-10
(EXC-F SIX DAYS)
x
. Remove screw .
1 2
.
3
.
1
.
2
M8
(
x
( p. 52)
x
(
x
( p. 50)
x
. Remove the front fender.
1
p. 45)
p. 45)
M20x1.5 12 Nm (8.9 lbf ft)
M8 17 Nm
(12.5 lbf ft)
17 Nm Loctite
(12.5 lbf ft)
p. 45)
p. 49)
p. 48)
54
® 243™