Wall-Mount Instruction; Attaching Wall Mount Arm; Preparing To Install Wall Mount Arm - Planar PLL2210MW User Manual

Wall-mount instruction

Preparing To Install The Optional Wall Mount Arm (not included)
This LED Monitor can be attached to a wall mounting arm you can purchase separately.
Turn the power OFF then disconnect the cables from the LED Monitor before performing the
procedure below.
1. Lay the LED Monitor face down on a soft surface.
2. Remove the hinge cover.
3. Remove the one screw holding the stand to the hinge.
4. Remove the stand.
Attaching The Optional Wall Mount Arm (not supplied)
Follow these steps to finish installing the wall mounting arm:
1. Place the wall mounting arm onto the back of the LED
Monitor. Line up the holes of the arm with the holes in the
back of the monitor.
2. Insert the 4 screws into the holes and tighten.
3. Reconnect the cables. Refer to the User's Guide that came
with the optional wall mounting arm for instructions on
attaching it to the wall.
NOTE
• 100mmx100mm VESA high hole (n=4), M4, pitch =0.7 mm
screw mounting kit not included.
14
100mm x 100mm Screw
Mounting Options
4mm, 0.7 pitch
threaded holes x 4