Table of Contents
Advertisement
Fault handling
DCU II (Display Control Unit)
DIAGNOSTICS
If the system detects a malfunction the driver/operator
is informed via a pop-up message on the display. The
fault codes are listed in the diagnostics menu; active
fault codes are at the top of the list and are denoted by
a green dot. For more detailed information regarding
the cause and remedies, use the arrow buttons to scroll
to the fault concerned and press
. This will also
provide information about the number of engine hours
when the fault became active and the SPN and FMI
codes.
Erasing fault codes
The memory of the diagnostic function is reset when
the power to the engine is disconnected. When the
power is switched on again, the diagnostic function will
check if there are any malfunctions in the system. If so
a new fault codes is registered.
If a malfunction has not been corrected it will be
registered once again and has to be acknowledged
again.
47710925 01-2019 © AB VOLVO PENTA
45
Hide quick links:
Advertisement
Table of Contents
