Omron sysmac NX Series User Manual page 23

• For the installation orientations in the following figure, support the cables, e.g., with a duct, so that
the End Plate on the bottom is not subjected to the weight of the cables. The weight of the cables
may cause the bottom End Plate to slide downward so that the Slave Terminal is no longer secured
to the DIN Track, which may result in malfunctions.
Wiring
• Double-check all switches and other settings and double-check all wiring to make sure that they are
correct before turning ON the power supply.
• Use the correct wiring parts and tools when you wire the system.
• Do not pull on the cables or bend the cables beyond their natural limit. Also, do not place heavy
objects on top of the cables or other wiring lines. Doing so may break the cable.
• When wiring or installing the Units, do not allow metal fragments to enter the Units.
• Do not press the flat-blade screwdriver straight into the release holes on a screwless clamping ter-
minal block. Doing so may damage the terminal block.
NG
• When you insert a flat-blade screwdriver into a release hole on a screwless clamping terminal block,
press it down with a force of 30N or less. Applying excessive force may damage the terminal block.
• Do not incline or twist the flat-blade screwdriver while it is in a release hole on a screwless clamping
terminal block. Doing so may damage the terminal block.
NX-series System Units User's Manual (W523)
Restricted
region (shaded
portion)
Upper
Lower
OK
Precautions for Safe Use
21