Omron sysmac NX Series User Manual page 119

When you use any ferrules other than those in the above table, crimp them to the twisted wires so
that the following processed dimensions are achieved.
1.6 mm max. (except ground terminals)
2.0 mm max. (ground terminals)
 Using Twisted Wires/Solid Wires
If you use twisted wires or solid wires, use the following table to determine the correct wire specifi-
cations.
Terminals
Classifica-
tion
All termi-
nals except
ground ter-
minals
Ground
terminals
*1. Secure wires to the screwless clamping terminal block. Refer to Securing Wires on page 4-51 for how to
secure wires.
*2. With the NX-TB£££1 Terminal Block, use twisted wires to connect the ground terminal. Do not use a
solid wire.
Conductor length (stripping length)
NX-series System Units User's Manual (W523)
Twisted wires
Current Unplat-
Plated
capacity
2 A max. Possible Possible
Greater Not pos-
than 2 A sible
and 4 A or
less
Greater Possi-
than 4 A
*1
ble
--- Possible Possible
8 to 10 mm
2.4 mm max. (except ground terminals)
2.7 mm max. (ground terminals)
Wire type
Solid wires
Unplat-
Plated
ed ed
Possible Possible
Possi- Not pos-
sible
*1
ble
Not pos-
sible
Possi- Possi-
*2 *2
ble ble
4 Installation and Wiring
Conductor
Wire size length (strip-
ping length)
8 to 10 mm
2
0.08 to 1.5 mm
(AWG28 to 16)
9 to 10 mm
2
2.0 mm
4
4-47