Fan - HP EliteDesk 800 G4 SFF Maintenance And Service Manual

Fan

The fan is secured to the back of the computer.
IMPORTANT:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the air duct
4. Remove the fan sink
5. Disconnect the fan cable from the system board connector labeled CHFAN2 (1), and then loosen the four
captive screws (2) that secure the fan sink to the system board tray.
6. Press the release button (2), and then rotate the fan downward and remove it from the computer (3).
To install the fan, reverse the removal procedure.
The rear fan is used only in models with a 95 W processor.
(Access panel on page
(Air duct on page
(Fan sink on page
(Preparation for disassembly on page
18).
51).
54).
17).
Fan 57