Table of Contents
Advertisement
EVGA X299 Micro ATX 2 (121-SX-E296)
In the "SATA Mode Selection" at the top, the default will be AHCI. Click on the arrow
to the right side of AHCI or navigate to it with your keyboard and press "Enter" to
open the pulldown menu. Select RAID from the list.
RAID mode not only includes the RAID controls, but also shares the same
options/functions/commands as AHCI; you may continue using your AHCI devices
normally when the SATA Configuration is set to RAID mode.
The SATA Information menu shows a list of all drives currently detected by the
controller; make sure the list in your BIOS matches what you have plugged in. If it does
not, reseat cables on the device(s) in question. If the issue persists, please check the
troubleshooting section on Page 123.
- 65 -
Advertisement
Table of Contents
