Connecting A Susi Module (Except Ld-G-31 Plus); Connecting A Clock Generator To The Ld-G-36 Plus; Fixing The Decoder - tams elektronik 30 plus Series Manual

English Locomotive decoders of the series 30 plus
6.18. Connecting a SUSI module
(except LD-G-31 plus)
The SUSI interface is a standardized interface for the connection of
accessory modules to a vehicle decoder. Controlling the SUSI module has
to be carried out by the vehicle decoder. In order to make the necessary
settings for the SUSI module you have to program the decoder.
The decoder (except LD-G-36 plus with 21MTC- or 21-pole interface)
has a soldered SUSI-plug, fit to insert the socket of the SUSI module.
With the LD-G-36 plus with MTC- or 21-pole interface you can solder a
SUSI module on the soldering pads provided for that purpose.
There are connections according to SUSI integrated in the 21MTC-and
the PluX22 interface, as well. Only the decoder versions without PluX-
plug or MTC-socket are suitable for connecting an external SUSI
module to these connecting points.
Please note, that with the locomotive decoder LD-G-33 plus you can
either connect a SUSI module or use the switching inputs. With the
decoders LD-G-34 plus and LD-G-36 plus you can both connect a SUSI
module and use the switching inputs.

6.19. Connecting a clock generator to the LD-G-36 plus

You can control for example the correct synchronisation of the steam
discharge with the wheel movements. For that purpose connect a reed
contact or a Hall sensor as a clock generator and fix two or more mini
magnets to the wheels. When connecting a Hall sensor observe the right
polarity.

6.20. Fixing the decoder

After having finished all connections you should fix the decoder, to
avoid short circuits by contact to metal parts of the vehicle, for
example. You can use double sided adhesive tape for it, for example.
Page 54