Releasing The Functions - tams elektronik 30 plus Series Manual

Locomotive decoders of the series 30 plus

sensitivity to load changes;

time of no-load running;

assignment of the sounds to the function keys.

4.5. Releasing the functions

The function outputs, the servo output, the integrated sounds and with
the LD-G-36 plus the driving sounds can be released by:

pushing the function keys and / or

automatically via the two switching inputs. The switching inputs are
released via external contacts, e.g. via reed contacts or Hall sensors
in combination with permanent magnets in the rails.
Hint for locomotive decoder LD-G-33 plus: When there is connected a
SUSI module, the switching inputs are not available.
Hint for locomotive decoders LD-G-34 plus and LD-G-36 plus: The
sounds of a connected SUSI module can be triggered by the function
keys as well as by the switching inputs that are assigned to these
function keys. .
Mapping of the outputs to the function keys
The mapping of the outputs to the function keys and the switching
inputs is arbritary. It is possible to assign several function keys and
switching inputs to one output.
Output
F0f / F0r
AUX1 to AUX6
(LD-G-31 plus: AUX1 to AUX2)
AUX7
(versions with connections
according to PluX only, except LD-G-31 plus)
All function outputs can be switched inverted, i.e. when set to position
"on" the assigned function output will be switched off, when set to
position "off" switched on.
DCC format
F0 to F12
F0 to F28
F13 to F28
English
MM format
F0 to F4 or
F5 to F9
(= F0 to F4 of a
second decoder
address)
Page 19