Connecting The Switching Inputs - tams elektronik 30 plus Series Manual

English

6.17. Connecting the switching inputs

Depending on the decoder type and layout you can connect
components to be used to trigger the switching inputs (e.g.
reedcontacts or Hall sensors) either directy to the soldering points or
via the SUSI interface. With the decoder versions equipped with a SUSI
plug (LD-G-33 plus and LD-G-36 plus in the PluX version), you need a
SUSI socket with wire for the connection of the switching inputs (e.g.
item no. 70-01111).
LD-G-31 plus
LD-G-33 plus *
LD-G-33 plus *
LD-G-34 plus
LD-G-36 plus *
LD-G-36 plus *
* 5 With the LD-G-33 plus you can either use the switching inputs or
connect a SUSI module. With the LD-G-36 plus you can simultaneously
use the switching inputs and connect a SUSI module, the SUSI module
has to be connected to the appropriate connections of the PluX
interface in this case.
The switching inputs switch respective to the decoder ground and thus
can be connected to all (external) circuits allowing to make contact to
Page 52
Locomotive decoders of the series 30 plus
Versions
all
5 without wires,
NEM652-plug
5 PluX22, 21 MTC,
21-pole
all
5 PluX22, without
wires, NEM652-
plug
5 21 MTC,
21-pole
Soldering SUSI-interface
points
X13 | X14
X3 | X4
X16 | X17
---
---
---
via
SUSI-socket
via
SUSI-socket
---
via
SUSI-socket
Soldering
points
X24, X25