Configuration Variables And Registers - tams elektronik 30 plus Series Manual

English

8. Configuration variables and registers

In the lists you will find in the column "No." the numbers of the
configuration variables for programming in DCC format. The numbers of
the registers for programming in Motorola format are identical to the CV
numbers. The defaults are those values set in the state of delivery and
after a reset.
Please note: With variables destined to set several parameters, the
input value has to be calculated by adding the numerical values
assigned to the desired parameters.
Setting the address
Name of CVs /
registers
Basic address
Tip: If a value higher than 127 is set for the basic address and the use of extended addresses
in CV#29 is set to off, the decoder does not react to signals in DCC format!
Extended
address
Consist
address
2nd Motorola
address
Page 58
Locomotive decoders of the series 30 plus
No. Input value
(Default)
1 1 ... 255
(3)
17 192 ... 255
(192)
18 0 ... 255
(255)
19 1 ... 127
47 0 ... 255 (4)
Remarks and Tips
Range of values in
DCC-Format: 1 ... 127
Only for DCC format. Most
central units permit entering
extended addresses directly.
The CVs # 17, 18 and 29 are
set automatically to the proper
values.
(0) = 2nd adress
In DCC format only!
= Address needed to switch
additional functions in Motorola
format. The function keys F5 to
F8 are reached via the function
keys F1 to F4, the function key
F9 via the function key F0.