Fr Notice D'utilisation Originale - Hilti TE 70-AVR Original Operating Instructions

Trouble or fault
Combihammer does not
achieve full power.
Drill bit does not rotate.
Drill bit is not released.
The service indicator blinks
red.
The service indicator lights
red.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10 RoHS (Restriction of Hazardous Substances)
Click on the links to go to the table of hazardous substances: qr.hilti.com/r1021413
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Notice d'utilisation originale
1 Indications relatives au mode d'emploi
1.1 À propos de ce mode d'emploi
• Avant de mettre l'appareil en marche, lire impérativement ce mode d'emploi.
préalablement requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements du présent mode d'emploi ainsi que celles
figurant sur le produit.
• Toujours conserver le mode d'emploi à proximité du produit et uniquement transmettre le produit à des
tiers accompagné de ce mode d'emploi.
18 Français
Possible cause
The control switch is not fully
pressed.
The voltage provided by the elec-
tric supply is too low.
The function selector switch is not
engaged or is in the "Chiseling"
position or the "Chisel position-
ing" position .
The chuck is not pulled back fully.
The side handle is not fitted cor-
rectly.
A fault has occurred in the tool.
The carbon brushes are worn.
Action to be taken
▶ Press the control switch as far
as it will go.
▶ Connect the power tool to a
different power source.
▶ With the motor at a standstill,
set the function selector switch
to the "Hammer drilling"
position.
▶ Pull the tool lock back as far
as it will go and remove the
accessory tool.
▶ Disengage the side handle and
refit it correctly so that the
clamping band and side handle
engage in the recess.
▶ Have the product repaired by
Hilti Service.
▶ Have checked, and if necessary
replaced, by a trained electrical
specialist.
C'est la condition
2063038
*2063038*