Correcting The Installation Angle - Pioneer AVIC-D2 Operation Manual

(5) Power Voltage
The power supply (reference value) provided
from the vehicle battery to the navigation sys-
tem is shown. If the voltage does not fall
within the range of 11 to 15V, check that
power cable connection is correct.
(6) Illumination
When the headlights or small lamps of a vehi-
cle are on, "On" is displayed. (If the orange/
white lead is not connected, "Off" appears.)
(7) Back Signal
When the gear lever is shifted to "R", the sig-
nal switches to "High" or "Low". (Which of
these is displayed depends on the vehicle.)
62
Correcting the Installation
Angle
You can correct the installation angle of the navi-
gation system. Correcting the installation angle
improves the accuracy for sensor learning, even
if the unit is not facing center. Select the orienta-
tion of the LCD panel from the left, center, and
right.
1
Touch "Settings" in the Main menu, then
touch "System Options".
2
Touch "Installation Angle Setup".
3
Check the direction the LCD panel faces,
and touch the corresponding item.
Facing Left :
Select this when the angle is 5° or more to the
left from the center.
Facing Center :
Select this when the angle is less than 5° to
the left, and 5° or more to the right from the
center.
Facing Right :
Select this when the angle is 5° or more to the
right from the center.
❒ If the sensor status is "Simple hybrid",
the installation angle can be corrected.