Checking The Connections Of Leads And Installation Positions - Pioneer AVIC-D2 Operation Manual

(4) Degree of learning
Sensor learning situations of distance (Dis-
tance), right turn (Right Turn), left turn (Left
Turn), and 3D detection (3D Detection) are
indicated by the length of bars.
❒ When tires have been changed or chains fit-
ted, turning on the Speed Pulse allows the
system detects the fact that the tire diameter
has changed, and automatically replaces the
value for calculating distance.
❒ If the ND-PG1 is connected, the distance cal-
culation value cannot be replaced automati-
cally.
(5) Speed
Speed detected by the navigation system is
indicated. (This indication may be different
from the actual speed of your vehicle, so
please do not use this instead of the speedom-
eter of your vehicle.)
(6) Acceleration or deceleration/Rota-
tional speed
Acceleration or deceleration velocity of your
vehicle is indicated. Also, rotational speed
when your vehicle turns to left or right is
shown.
(7) Inclination
Degree of slope of the street is indicated.
To clear values...
If you want to delete the learned results stored in
"Distance", "Speed Pulse" or "Learning Sta-
tus", touch the relevant result, then touch
"Clear".
❒ The navigation system can automatically use
its sensor memory based on the outer dimen-
sions of the tires.
Checking the connections of
leads and installation positions
Check that leads are properly connected between
the navigation system and the vehicle. Please
also check whether they are connected in the
correct positions.
1
Touch "Settings" in the Main menu, then
touch "Hardware Info".
2
Touch "Connection Status".
The Connection Status screen appears.
(1) Speed Pulse
The Speed Pulse value detected by the naviga-
tion system is shown. "0" is shown while the
vehicle is stationary.
(2) GPS Antenna
Indicates the connection status of the GPS
antenna, the reception sensitivity, and from
how many satellites the signal is received.
If the signal is received correctly, "OK" is dis-
played. If reception is poor, "NOK" appears.
(3) Installation Position
The Installation position of the navigation sys-
tem is shown.
If installed correctly, "OK" appears. Indicates
whether the Installation position of the naviga-
tion system is correct or not. When the navi-
gation system is installed at an extreme angle
exceeding the limitation of the installing
angle, "Incorrect angle" will be displayed.
When the angle of the navigation system has
been changed, "Excessive vibration" will be
displayed.
(4) Parking Brake
When the parking brake is applied, "On" is
displayed. When the parking brake is
released, "Off" is displayed.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
61