Installation; Precautions Before Installation; To Avoid Electromagnetic Interference; Before Installing - Pioneer AppRadio SPH-DA100 Installation Manual

Installation

Precautions before
installation
CAUTION
• Never install this product in places
where, or in a manner that:
– Could injure the driver or passengers
if the vehicle stops suddenly.
– May interfere with the driver's opera-
tion of the vehicle, such as on the
floor in front of the driver's seat, or
close to the steering wheel or gear-
stick.
• Make sure there is nothing behind the
dashboard or panelling when drilling
holes in them. Be careful not to dam-
age fuel lines, brake lines, electronic
components, communication wires or
power cables.
• When using screws, do not allow them
to come into contact with any electrical
lead. Vibration may damage wires or
insulation, leading to a short circuit or
other damage to the vehicle.
•
To ensure proper installation, be sure
to use the supplied parts in the manner
specifi ed. If any parts are not supplied
with this product, use compatible parts
in the manner specifi ed after you have
the parts' compatibility checked by
your dealer. If parts other than supplied
or compatible ones are used, they may
damage internal parts of this product
or they may work loose and the prod-
uct may become detached.
• It is extremely dangerous to allow
cables to become wound around the
steering column or gearstick. Be sure
to install this product, its cables, and
wiring away in such so that they will
not obstruct or hinder driving.
• Make sure that leads cannot get caught
in a door or the sliding mechanism of a
seat, resulting in a short circuit.
• Please confi rm the proper function of
your vehicle's other equipment after
installation of this product.
• Do not install this product where it may
(i) obstruct the driver's vision, (ii)
impair the performance of any of the
vehicle's operating systems or safety
features, including airbags, hazard
lamp buttons or (iii) impair the driver's
ability to safely operate the vehicle.
• Install this product between the driv-
er's seat and front passenger seat so
that it will not be hit by the driver or
passenger if the vehicle stops quickly.
• Never install this product in front of or
next to the place in the dashboard,
door, or pillar from which one of your
vehicle's airbags would deploy. Please
refer to your vehicle's owner's manual
for reference to the deployment area of
the frontal airbags.
To avoid electromagnetic
interference
In order to prevent interference, set the fol-
lowing items as far as possible from this
product, other cables or leads:
FM, MW/LW aerial and its lead
•
• GPS aerial and its lead
In addition, you should lay or route each
aerial lead as far as possible from other aer-
ial leads. Do not bind, lay or route them
together, or cross them. Electromagnetic
noise will increase the potential for errors in
the vehicle's location display.

Before installing

Consult with your nearest dealer if installa-
•
tion requires drilling holes or other modifi-
cations of the vehicle.
Before making a final installation of this
•
product, temporarily connect the wiring to
confirm that the connections are correct
and the system works properly.
Section
03
13
Engb