Table of Contents
Advertisement
B-4
CASE FRONT CONTROLS
All operator controls and adjustments are located on
the case front of the Power Wave. (See Figure B.1)
1. LEFT DISPLAY- Shows wire feed speed or amper-
age,
2. LEFT KNOB- Adjusts value in left display.
3. MAIN DISPLAY- Shows detailed welding and diag-
nostic information.
4. LEFT BUTTON- Changes the Main display to
show the Weld Mode or Arc Control.
5. MAIN KNOB- Changes the values on the Main dis-
play.
6. PROCEDURE BUTTON- Selects A or B proce-
dure, or gun control.
7. 2-STEP/4-STEP BUTTON- Toggles between 2-
step and 4-step trigger operation.
8. MEMORIES BUTTONS- For selection of common
procedures.
OPERATION
FIGURE B.1
1
2
3
4
5
6
7
8
9
POWER WAVE
9. ON/OFF SWITCH- Controls power to the Power
Wave
C300.
®
10. RIGHT DISPLAY- Shows voltage or trim.
11. THERMAL LIGHT- Indicates when machine has
thermal fault.
12. RIGHT KNOB- Adjusts value in right display.
13. SET-UP- Lights when machine is in set-up mode,
14. RIGHT BUTTON- Used to toggle start options
and to end options.
C300
®
B-4
10
11
12
13
14
Advertisement
Table of Contents
