Design Features; Case Front Controls - Lincoln Electric POWER WAVE S500 Operator's Manual

POWER WAVE ® S500

DESIGN FEATURES

Loaded with Standard Features
• Multiple process DC output range: 5 - 550 Amps
• 200 – 600 VAC, 3 phase, 50-60Hz input power
• New and Improved Line Voltage Compensation
holds the output constant over wide input voltage
fluctuations.
• Utilizes next generation microprocessor control,
®
based on the ArcLink
• State of the art power electronics technology yields
superior welding capability.
• Electronic over current protection
• Input over voltage protection.
• F.A.N. (fan as needed). Cooling fan only runs
when needed.
• Thermostatically protected for safety and reliability.
• Ethernet connectivity.
• Panel mounted Status and Thermal LED indicators
facilitate quick and easy troubleshooting.
• Potted PC boards for enhanced ruggedness/relia-
bility.
• Enclosure reinforced with heavy duty aluminum
extrusions for mechanical toughness
• Waveform Control Technology™ for good weld
appearance and low spatter, even when welding
nickel alloys.
• Sync Tandem installed.
platform.

CASE FRONT CONTROLS

(See Figure B.1)
1. USER INTERFACE (optional)
2. STATUS LED - (See Troubleshooting Section for
operational functions)
3. THERMAL LED - Indicates when machine has
thermal fault.
4. POWER SWITCH - Controls power to the POWER
®
WAVE S500.
5. NEGATIVE WELD OUTPUT
6. POSITIVE WELD OUTPUT
7. WORK SENSE LEAD CONNECTOR
8. 12-PIN CONNECTOR (Optional)
FIGURE B.1
1
2
3
4
5
6
7
B-3
OPERATION
8