Table of Contents
Advertisement
DUAL MAVERICK
®
450 (AU)
1
2
3
4
5
23
6
7
8
CASE FRONT CONTROLS
1. LCD SCREEN, IP67 RATED OPERATOR A - The LCD screen
displays information about welding mode, output voltage or
current, engine status and machine settings. It allows
operator to select welding mode and read the output voltage
or current when presetting using the output control knob.
During welding, the screen displays the actual output voltage
(VOLTS) and current (AMPS). A memory feature holds the
screens on for 5 seconds after welding is stopped. This
allows the operator to read the actual current and voltage just
prior to when welding was ceased. In engine status section,
information about engine hours, filter condition, engine oil
and other service items are displayed..
2. OUTPUT CONTROL OPERATOR A - The OUTPUT KNOB is used
to preset the output voltage or current as displayed on the
LCD screen for the six welding modes. When in the ARC
GOUGING or CV-WIRE modes and when a remote control is
connected to the 6-Pin or 14-Pin Connector, the auto-sensing
circuit automatically switches the OUTPUT CONTROL from
control at the welder to the remote control. When in
12
11
3. SINGLE/DUAL OPERATOR MODE SWITCH - The switch allows
4. 14-PIN WIRE FEEDER CONNECTION OPERATOR A - For
5. WIRE FEEDER POLARITY SWITCH - Matches the polarity of the
6. 6-PIN REMOTE CONTROL CONNECTOR OPERATOR A - For
A-6
13
14
24
DOWNHILL PIPE and CC-STICK modes if a remote control is
connected to the 6-Pin or 14 Pin Connectors, the output is
controlled by the remote and the output control on the
machine is used to set the maximum current range for the
remote.
the user to choose between Single Operator and Dual
Operator weld modes. Single Operator mode is when the
switch is in the "Left" position. Dual Operator mode is when
the switch is in the "Right" position.
attaching wire feeder control cables. Includes contactor
closure circuit, auto-sensing remote control circuit, and 42V
power. The remote control circuit operates the same as the
6 Pin Amphenol. NOTE: That 115V is not available.
wire feeder voltmeter to the polarity of the electrode.
attaching optional remote control equipment. Includes auto-
sensing remote control circuit.
INSTALLATION
15
17
16
18
19
20
21
22
10
9
Advertisement
Table of Contents
